Support Center logo
Support Center logo

All articles

Install the Conduit Installation Plate for UYB-20 Floor-Ceiling Flex SystemsUpdated an hour ago

Introduction

This article explains how to install the conduit installation plate for UYB-20 floor-ceiling flex systems. 

The conduit installation plate can be installed on the ceiling or the wall. 

Ceiling Installation

1.    Attach the sheath connection (not supplied) to the wire hole of the conduit installation plate.

2.    Attach the conduit installation plate to the unit's chassis.

Wall-Mounted Installation

1.    Attach the sheath connection (not supplied) to the wire hole of the conduit installation plate.

2.    Attach the conduit installation plate to the unit's chassis.

Knockout Holes

During installation, open the corresponding round knockout holes as shown in the illustration. Rectangular knockout holes are not permitted. 

Wire Hole

1. Rubber rings are used to fill the excess space in the three crossing holes of the electronic control box. 

2. The installation plate is used to block the bottom outlet holes when routing cables through the side. 

Was this article helpful?
Yes
No