Install RYB-20 Ducted Ceiling Concealed Systems: Getting StartedUpdated 2 hours ago
Introduction
This article provides an overview of the installation process for RYB-20 ducted ceiling concealed systems.
Each section in this article represents a step in the installation process. Click the link in each section to learn about that specific step.
Note: Before beginning the installation, refer to the label on the product box to ensure the model number of the indoor unit matches the model number of the outdoor unit.
1. Select the Installation Location for the Indoor & Outdoor Units
We recommend understanding the criteria for selecting ideal locations for the indoor and outdoor units.
- The guidelines for selecting ideal installation locations for the indoor and outdoor units can be found in this article.
2. Install the Indoor Unit
Begin the installation by hanging the indoor unit. Then, connect the ducting, install the filter, and drill the wall hole for the piping.
- For information on hanging the indoor unit, click this link.
- Read this article for information on installing the air ducting.
- Get information on installing the filter for the indoor unit by clicking this link.
- Learn more about drilling the wall hole for the piping by reading this article.
3. Connect the Drainpipe
Attach the drainpipe to direct water away from the unit. Improper installation may cause unit and property damage.
- Click this link to learn how to connect the drainpipe.
4. Install the Outdoor Unit
Next, install the drain joint for the outdoor unit, then mount the unit to the ground or a wall-mounted bracket.
- For information on installing the drain joint for the outdoor unit, click this link.
- Read this article to learn about mounting the outdoor unit.
5. Connect the Refrigerant Pipes
Once the indoor and outdoor units are installed, connect the refrigerant pipes.
- Click this article for information on connecting the refrigerant pipes.
6. Connect the Electrical Wires
Connect the electrical wires for the system, starting with the outdoor wires followed by the indoor wires.
- Get information on connecting the wires by clicking this link.
7. Evacuate the Refrigerant Circuit
Use a vacuum pump and manifold gauge to evacuate the refrigerant circuit, removing any non-condensable gas and moisture from the system.
8. Perform a Test Run
Perform the test run after the entire system has been completely installed. Failure to perform the test run may result in unit damage, property damage, or personal injury.
- For instructions on performing a test run, read this article.