Support Center logo
Support Center logo

All articles

Activate Heat Mode Using Diamante Pro Series RemotesUpdated a day ago

Introduction

Understand how to use the Diamante Pro High-Wall (WYT-20S) series remote to activate the system’s heating mode.

Most Diamante Pro series remotes have manual DIP-switches below the battery compartment to control the heat setting. Adjust the switch position to change the control type and unit of temperature.

Steps

  1. Set the switch to the Heat position.
  2. Remove the batteries from the remote control.
  3. Wait at least 30 seconds.
  4. Reinsert the batteries into the remote control.

Note: If the switch is already set to the Heat position and the system is not entering heating mode, remove the batteries and reinsert them after 30 seconds. Then, try to activate heating mode again.  

Use the diagram below to help you properly configure the remote control settings:

Was this article helpful?